Chevy Conversion Status

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Vaughn [] on Sunday, November 19, 2023 at 14:46:22 :

- The rear mounts and torque moderator are done,

- Bolts secured by wire,

- Carb will set good,

- Engine is raked and should not experience propeller shaft vibration based on service bulletin posted below. It is between 3/8 and 1/2 inch lower at rear,

- Based on frame at rear of engine, and the two engine mount bolts in front, engine is straight in frame, sets 3/4 inch to the right off-center.

It was a little bit of work, but was fun doing. Now to move to the front and start the front engine mounts.

Follow Ups:

Post a Followup

Optional Link
Optional Image Link

(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button