Re: vent window gasket install

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Hayden [] on Monday, February 01, 2021 at 07:27:32 :

In Reply to: Re: vent window gasket install posted by scott56 [] on Sunday, January 31, 2021 at 18:14:30 :

After soaking the rectangular washer in PB, putting the threaded post between two blocks of wood in the vice, heating it with a burnzomatic, and methodically tapping each side with a flathead and hammer, the washer worked its way off of the squared post. After that the gasket install was very easy. Start on the end with the strike plate for the vent window latch. Thread the plate through the slit in the gasket as your first reference point. I lubed the inside of the channel with WD, and just used a pair of pliers to work the gasket into the channel. If you are worried about marring the back of the channel, tape it or use rubber pliers.

Follow Ups:

Post a Followup

Optional Link
Optional Image Link

(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button