Posted by Clint Dixon [126.96.36.199] on Wednesday, June 05, 2019 at 10:06:34 :
In Reply to: PTO Conical Bolts posted by Vaughn [188.8.131.52] on Tuesday, June 04, 2019 at 19:28:35 :
I am not so sure those will work correctly. When I reverse engineered original bolts, I found that the taper was 90 degrees. I have since sent the drawings to a reader here with the intent to reproduce some bolts. The problem is that is a special taper. Normal taper for inch hardware is 82 degrees. 90 degree taper is normally found on metric hardware.
They might still align the pto to the transmission housing, but the head of the bolts will not be seating fully or correctly.
Post a Followup