Posted by Nick [220.127.116.11] on Sunday, April 07, 2019 at 23:33:21 :
In Reply to: Steering issue update posted by Nick [18.104.22.168] on Sunday, April 07, 2019 at 20:10:01 :
So I postponed dinner cuz I was majorly curious if this would fix the slop once it was mounted.
So I fought with getting it back in. Forgot that I had to take the shaft out of the box to get the whole thing to clear the master cylinder and motor to get it out, so once i realized that and took it back apart, it went right in.
Got it all bolted up and attached the A arm and centered. Slight slop on grabbing the wheel and shaking. So I turned the adjusting screw farther in, and farther in and farther in. Eventually the slop disappeared and all was tight. Only thing that concerns me a little is the cap that goes over the adjusting screw, is only on like three or four threads and I think it might be stripped. So I put a good dose of thread locker on and seems to be ok.
I think this is solved! No slop in the shaft side to side, and no slop in the wheels side to side.I guess I'll know for sure after I finish the other little fixes and can actually test drive it
Post a Followup