Re: axle bushings and seals

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Vaughn [] on Monday, February 11, 2019 at 12:17:04 :

In Reply to: axle bushings and seals posted by Don in MD [] on Monday, February 11, 2019 at 08:43:21 :

Look at the bottom of the page and you'll the the bushing puller. You can make one using a long threaded rod, nut & washers on one end, and a piece of flat stock. Drill a hole in the flat stock, then move the drill side to side to create a elongated hole so it will slip sideways through the bushing. Use a piece of wood on the trunnion with a hole and washers and nuts to hold the rod from turning while turning a nut against the wood. Hope you get the picture. When you install the seal and bushing, drive the seal and bushing in together to keep the seal from deforming.

Follow Ups:

Post a Followup

Optional Link
Optional Image Link

(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button